Safety Operating Procedures for Industrial Gas Burners
Safety Operating Procedures for Industrial Gas Burners
First: Startup operation of gas burner:
1. For the newly installed gas burner body, carefully test whether the gas meets the requirements of the burner before commissioning; Check whether the test instrument on the air supply pipeline is normal, whether the pipeline valve is normally opened and closed, and whether it is convenient for future use and maintenance.
2. For newly installed pipes, carefully check the installation reliability and tightness of all pipes.
3. Users of the separate gasification station shall ensure that the gas supply volume and gas supply parameters meet the requirements of safe combustion.
4. The operator shall carefully read the operating instructions and master the knowledge and methods of safe operation.
5. Check whether the gas valve is opened before each startup, otherwise, the burner will not work.
6. Press the button to start the power control on the control cabinet. At this time, the digital display table will display the current furnace temperature, that is, the ambient temperature of the newly installed furnace.
7. Start the fan control button, and the fan installed on the furnace works. If the fan damages the control cabinet, it will be automatically protected from the next step.
8. When the combustion supporting fan works normally, start the combustion control button again. At this time, the combustion program controller starts to work.
9. When the combustion controller receives a signal unfavorable to combustion (for example, ignition failure, unstable air pressure, circuit problems, etc.), the combustion controller will immediately shut down the gas and send an alarm signal.
10. If the combustion controller gives an alarm, it must be manually reset by the operator after the fault is solved before continuing to work.
11. For the operation of the whole equipment, the operators shall refer to the furnace safety operation procedures and production process requirements.
12. The controlled temperature shall be adjusted according to the production process needs, and the operator shall manually adjust it by referring to the intelligent CNC workbench.
Second: Operation of gas burner:
1. There are two shutdown modes: automatic shutdown when the temperature in the furnace reaches the set value. At this time, the operator does not have to operate anything. When the temperature in the furnace is lower than the set value, the controller will start automatically.
2. In the case of manual shutdown and shift shutdown, the operator shall start the machine in reverse order (1. First turn off the combustion control button; 2. Then turn off the fan button; 3. Finally turn off the power supply and press the button;)
3. If the shutdown time is long, the operator shall close the gas pipeline valve to avoid gas leakage.