What is the Operation Process of the Low Nitrogen Burner?
What is the Operation Process of the Low Nitrogen Burner?
The maintenance of the low nitrogen burner is very convenient. The mixing device can be directly removed without removing the burner from the boiler. It can adapt to any type of combustion chamber. What is the operation process of the low nitrogen burner?
As long as the operation engineering of the low nitrogen burner is understood, maintenance and troubleshooting can be carried out when the combustion engine breaks down. Introduction to the operation process of the burner/incinerator Taking the multi-proportion gas burner as an example, its operation process has four stages: preparation stage, pre-purging stage, incineration stage, and normal incineration stage.
In the preparation stage of the low nitrogen burner, after the program control machine is powered on, the internal program self-test starts, and the servo motor drives the air valve to the closed state. After self-checking, the program is in standby mode. When the temperature controller, ultra-low air pressure switch, steam pressure switch of steam boiler and other constraint switches are, the program-controlled machine starts to start and enters the pre-purging stage.
If the solenoid valve of the low nitrogen burner is equipped with a leakage detection system when the above constraint switch is agreed upon, the system will first detect the leakage of the valve, and then enter the pre-purging stage after passing the detection. In the pre-purging stage, the servo motor drives the air valve to the firing state, starts the fan motor, starts to supply air for 13 seconds, and blows in the air for pre-purging.